Tags

, , , , , , , , , , , , , , , , ,


  • Heat Repair In DC

  • Heat Repair In DC
    Out of all the home warming options available to home owners, gas furnace is one of the most energy efficient, with relatively low cost of operation. In North American climates, the cost of heating is one of the biggest expenses for a home owner. An energy efficient furnace is an ideal solution which saves a lot of money and also reduces air pollution.

  • Heat Repair In DC

  • Heat Repair In DC
    A lot depends on how you install the furnace. There are a lot of calculations involved in determining the exact system size, that will create the right ambient temperature for your home and give maximum efficiency. There are system sizing software programs available on websites of these types of furnace manufacturers. They can help you decide the right size for your system.

  • Heat Repair In DC

  • Heat Repair In DC

      Choose your furnace system only after thorough research regarding your requirements. Go for high efficiency furnaces as they save money for you. Otherwise you may end up paying a lot more for a system which is too over sized for your house, causing discomfort! Research market prices, before going ahead and check the installation cost.
  • Heat Repair In DC

  • Heat Repair In DC

  • How Does a Gas Furnace Work?
    Following are the four steps in which the furnace works:
    It absorbs cold air
    Air taken is filtered
    Air is heated with the use of a stainless steel heat exchanger
    Warm air is pushed out by a blower motor and conveyed through ducts to your rooms
    This is how your furnace works in short.
  • Heat Repair In DC
  • Heat Repair In DC
    Installation Procedure
    Let us get in to the installation procedure in easy to follow steps.
    Step 1: Shut Down Earlier System and Turn off Gas
    If there is an old gas furnace system you need to replace, then switch it off and most importantly turn off the gas being supplied to the system. This is essential as otherwise it may lead to gas leak hazard. Then you can detach the old system right off the ducts.

  • Heat Repair In DC
  • Heat Repair In DC
    Step 2: Check Duct Work and Clean it
    Check the existing duct work for your home. Get it cleaned and restructured if you need to. In case, you are putting in a new system, you will have to plan and design the duct work. Then of course, you will have to get it fabricated and installed.

  • Heat Repair In DC
  • Heat Repair In DC
    Step 3: Place the New System In
    Once you are ready with the duct work, unpack the new system and read the installation instructions given by the manufacturer. Then attach the new heater system in the wall and connect the gas ducts to it. Attach the power plug. Follow the instructions carefully.

  • Heat Repair In DC
  • Heat Repair In DC
    Step 4: Make Gas Connection
    Connect the gas outlet to the furnace. Check the ducts for any leakage, before you turn on the gas flow. If there is any leakage, repair it immediately. Then turn the gas on. It is a good idea to wait some time, before you start gas burning. If there is any gas smell, there is a possible leakage. Double checking is always better. If you find no problems, hit the gas ignition and you are back to being warm!

    Heat Repair In DC
    It is better if you are adept at gas furnace troubleshooting, as problems keep cropping up in these systems periodically. I will sign off by wishing you warm days ahead.

    Heat Repair In DC

    Advertisements